Spots
Source of spots [spot_source]
Define where the spotlist should come from. FFT of image is running MMBOX over the FFT of the raw image. The second option creates a full set of all spots within the resolution ranges. The third option does nothing, which only makes sense if the spotlist has been determined before. If not, the third option defaults back to the first one.
Filter spotlist with second lattice [spot_filter]
Define if from the determined spotlist some spots should be filtered out, by removing spots from the list that are too close to the second (bad) lattice. If you activate this function, then the parameter Spotlist filter exclusion radius defines the filter radius.
Spotlist filter exclusion radius [spot_exclusion_radius]
This parameter applies if you want to filter the spotlist, by removing all spots that are closer than a given distance from a node of the second lattice. All spotlist spots on the primary lattice, that are closer than the specified distance in pixels to a node of the second lattice, are removed from the spotlist.
Source of additional spots [addspots]
Choose the file where the additional spots are extracted from.
Keep old spots in addition to new ones (for APH file option) [keepOld]
Lets you decide if a completely new spotlist should be established or if the found spots should merely be added to the existing one. This applies only to the APH file option. When using the Unbent image as a source, then a new spotlist should always be generated.
For more information on the on the spot list see spotlist.